How to read your water report without being reassured by it
A Consumer Confidence Report is designed to demonstrate compliance, not to answer your question. Both things can be true, and knowing the difference is most of the skill.
Published 12 September 2026 · Checked against the certifiers' own listings
Every community water system in the United States must publish an annual Consumer Confidence Report by 1 July. It is free, it is specific to your supply, and it is the sensible first step before buying anything. It is also built to demonstrate compliance to a regulator, and that shapes what it shows you.
Start with the detection table
Skip the welcome letter. The substance is a table listing each detected contaminant with four columns: the level found, the range across samples, the MCL (the legal limit) and the MCLG (the level at which no health effects are expected, which is not enforceable and is sometimes zero).
Two habits make this table far more informative:
- Read the range, not the average. A single annual average can sit comfortably under the limit while individual samples run far above it. Seasonal contaminants make this vivid: atrazine peaks after spring application, disinfection by-products rise in warm months and at the far ends of a distribution network.
- Compare against the MCLG as well as the MCL. The legal limit is the outcome of a negotiation involving treatment cost and feasibility. The MCLG is the health-based figure. Where they differ, that gap is a policy judgement someone made on your behalf.
What the report structurally cannot tell you
Lead
This is the big one. Lead is almost never in the water leaving the treatment plant. It is picked up on the way to you — from lead service lines, brass fixtures and old solder, much of it inside your own building, after the utility's last sampling point.
Utilities test a small sample of high-risk homes and report a 90th-percentile figure. That is a statistic about a sample of houses, not a measurement of yours. If your building predates 1986, or you do not know what your service line is made of, the report cannot answer the lead question and a test of your own tap is the only thing that can.
The action level is currently 15 parts per billion. It drops to 10 ppb on 1 November 2027 under the Lead and Copper Rule Improvements. Note that it is an action level — a trigger for the utility to act — rather than a health threshold. EPA sets its maximum contaminant level goal for lead, the non-enforceable health-based figure, at zero.
Anything unregulated
The report covers regulated contaminants. Microplastics, most pharmaceutical residues, 1,4-dioxane and uranium in some circumstances may be absent simply because nobody is required to report them. Absence from the table is not evidence of absence from the water.
PFAS, for now
PFAS reporting is still arriving in these documents as the 2024 rule phases in. The better source today is EPA's UCMR 5 Data Finder, which publishes the 2023–2025 results of testing for 29 PFAS compounds by water system.
Where to find yours
- Your utility's website, usually filed under "water quality" or "CCR".
- EPA's CCR search, if the utility buries it.
- For PFAS specifically, EPA's UCMR 5 Data Finder at epa.gov/dwucmr.
- If you are on a private well, none of this applies to you. No one tests a private well but its owner. Arsenic, nitrate, uranium and bacteria are all real possibilities and all invisible.
The honest summary
Use the report for what it is good at: the contaminant profile of your source water, which is real information and costs nothing. Do not let it settle the lead question, because it cannot. And if you are about to spend several hundred dollars on a filter, a laboratory test of your own tap costs a fraction of that and replaces guessing with knowing.
Buying a filter for a contaminant you do not have is the most common expensive mistake in this category — and it is the one every manufacturer's marketing is quietly designed to encourage.